CVE-2026-19576 — Stack out-of-bounds write in the Goodix GT911 touch controller driver from an unvalidated device-reported touch point count
The Goodix GT9xx input driver in drivers/input/input_gt911.c reads the touch point count from the controller's status register and masks it with GT911_TOUCH_POINTS_MSK (0x0F), yielding a value of 0..15. In gt911_process() that value is used directly as the loop bound for filling point_reg[], a stack array sized to CONFIG_INPUT_GT911_MAX_TOUCH_POINTS, whose Kconfig range is 1..5 with a default of 1. No other check constrains the count; the driver relied only on a comment asserting that the controller had been programmed at init to report no more points than configured. Each loop iteration issues an I2C read of eight bytes straight into point_reg[i], so a controller that reports more points than the array holds causes up to 112 bytes of peer-supplied data to be written past the end of the array, over the stack frame of gt911_process() in the system workqueue thread. Two further loops then read out of bounds from the same array. Triggering it requires control of, or the ability to substitute, the I2C touch controller — plausible on the many supported boards where the GT9xx panel is a pluggable display module or shield rather than an on-PCB part; a spoofed device need only answer the init probes with a supported product ID and a checksum-valid config blob. The same overflow can also occur non-adversarially, with a GT9271-class panel that ignores the driver's touch-count programming and reports up to ten points, or with bus corruption of the single status byte. The impact is an out-of-bounds stack write with fully attacker-chosen content executing at kernel privilege, i.e. potential control-flow hijack on the host MCU, in addition to out-of-bounds reads and crashes. The attack vector is physical/local hardware access only; there is no network, USB, or syscall path to the defect. The fix clamps the reported count with min() against CONFIG_INPUT_GT911_MAX_TOUCH_POINTS before any array indexing.
Who exploits it and how urgent it is
A 0–100 score combining confirmed exploitation, ransomware and APT use, public exploits, EPSS and severity.
How the score was calculated
- EPSS 0.2% (30-day exploitation probability)+1
- Technical severity (medium)+3
The score orders the patch queue; it does not replace your asset context (internet exposure, criticality, compensating controls).
Triage
Is it exploited, how likely is exploitation, what does it touch, and how severe do the sources call it.
CISA SSVC assessment CISA
Three decision points CISA publishes for the CVEs it assesses (SSVC 2.0.3). A stakeholder decision, not a severity score.
Remediation
Fixes and mitigations documented by the sources — linked to the original advisory.
No fix documented by the sources we poll. That does not mean none exists: check the vendor advisory.
First 24 hours
Ordered from the record’s own fields — exposure first, because you cannot patch what you have not found. A rule-generated starting point.
- Identify exposed assets running the affected vendor/product/version combinations (Zephyrproject Zephyr).
- No fix documented in the sources: reduce exposure and monitor the vendor advisory.
- Search available logs for exploit probes matching the vulnerability class (memory corruption), errors and authentication anomalies.
Affected scope
Vendor, product and versions as the sources word them.
| Vendor | Product | Versions | Status | Source |
|---|---|---|---|---|
| Zephyrproject | Zephyr | ≥ 4.0.0 and ≤ 4.4.2 | Vulnerable | CVE Program (cve.org) e CISA ADP |
Attack characteristics
The CVSS vector, decoded. It describes the attack, not your exposure to it.
Every base score collected
Sources score independently and may disagree; each row says who scored it and under which version.
| Score | Version | Severity | Expl. | Impact | Scored by |
|---|---|---|---|---|---|
| 6.8 | CVSS 3.1 | Medium | 0.9 | 5.9 | vulnerabilities@zephyrproject.org via NIST National Vulnerability Database |
| 6.8 | CVSS 3.1 | Medium | — | — | zephyr via CVE Program (cve.org) e CISA ADP |
CVSS:3.1/AV:P/AC:L/PR:N/UI:N/S:U/C:H/I:H/A:H (score shown at the top: vulnerabilities@zephyrproject.org) Weakness MITRE
Weakness class according to MITRE’s CWE catalog.
EPSS over time FIRST
Oct 13, 2026 → Oct 15, 2026 · 3 reading(s) · max 0.17%
Detection
Read off the CVSS vector and the weakness class. Starting points, not tested rules.
- Local/physical vector: focus on endpoint telemetry (EDR) from affected hosts.
- Correlate service crashes/restarts with inbound traffic; repeated crashes may indicate attempts.
Timeline
What happened to this CVE, newest first.
- 2026
- SSVC assessment updated
- Affected products added · zephyrproject/zephyr
- Source status changed · Received → Awaiting Analysis
- Record published
- CVSS changed · 6.8
- Source status changed · → Received
- Record created in this database
- CVE published
Source activity
Repeated readings are counted rather than listed.
- 1× Official description updated · Oct 13, 2026 – Oct 13, 2026
References
2 on the record
Elsewhere on this site
Related CVEs (same products)
- Medium CVE-2026-75085 Out-of-bounds read from received-frame length underflow in the STM32WBA IEEE 802.15.4 driver 1d
- Medium CVE-2026-75083 Integer underflow of the radio-reported frame length causes an out-of-bounds write in the NXP KW41Z IEEE 802.15.4 driver 1d
- Medium CVE-2026-75084 Out-of-bounds write in the TI CC1200 IEEE 802.15.4 driver from an unvalidated radio-supplied packet length 1d
- High CVE-2026-19673 Out-of-bounds read and net_buf length underflow in Zephyr Ethernet L2 when parsing a truncated VLAN header 1d
- Medium CVE-2026-19940 Bluetooth HFP AG reuses a connection slot while a delayable work item is still armed, corrupting kernel timeout bookkeeping 2d
- Medium CVE-2026-19939 Bluetooth Classic AVDTP: stale timeout work on signalling-channel disconnect leads to kernel timeout-list corruption 2d
Not in any source we poll
Listed rather than left blank: an empty field and an unmeasured one look identical on screen, and only one is a reason to look elsewhere.
- No fixed version, patch or mitigation documented.
- No confirmed IOCs, IP addresses, domains, file hashes, or malware artifacts supplied.
- No organization-specific asset inventory, compensating-control status, or patch deployment evidence supplied.
- No exploit packet captures, log samples, or incident case IDs supplied.
Answered from this record
Text assembled only from the fields above — no additional claims.
What should defenders know first?
CVE-2026-19576 is "Stack out-of-bounds write in the Goodix GT911 touch controller driver from an unvalidated device-reported touch point count", rated Medium. It affects Zephyr (Zephyrproject); versions are in the scope table. It is not in CISA KEV, which does not rule out exploitation. CVSS 6.8 describes technical severity. EPSS 0.17% estimates the probability of exploitation in 30 days; neither replaces your asset context. First verify whether exposed or business-critical assets run the affected versions, apply vendor fixes or mitigations, and preserve logs for review.
Comments
Moderated technical discussion. Read the community guidelines.
No comments yet.
Sign in or create an account to comment and suggest corrections.